Tire wear is also one of the sources of plastic pollution

A recent paper published by the Norwegian Air Institute pointed out that roads are also one of the routes of plastic pollution. The main sources of plastic pollution on roads are tire wear and brake wear. At present, road plastic particle emissions account for 30% of the overall plastic particle pollution, most of which comes from densely populated areas.

Plastic is a completely man-made material. It was created in the Dow’s laboratory in the 1950s. In less than 100 years, it has penetrated into all aspects of people’s lives. Various regions and countries have only issued plastic bans. Can prohibit some non-essential plastic products, such as plastic straws, plastic dinner plates, etc.

Plastic particles are a new research direction for plastic pollution. Plastic particles were first detected in fish meat and then detected in the human body. Compared with the overall plastic waste in the ocean, plastic particles are more harmful to the environment. So, how exactly are plastic particles produced?

No. 6 plastic, also known as foam. Foam can be recycled. There is a crushing process during the foam recycle process. The rotating cutter built into the foam compactor will crush the foam waste into foam. The particle size of Foam dust is small enough, but the foam waste flowing into the natural environment is faced with a “cutter” that is wind or water flow. These two “cutters” can decompose the foam to be smaller and form plastic particles.

After the recovered foam waste becomes dust, it can be compressed into a blocks and finally sent to the terminal manufacturer to become a commodity again. The plastic particles decomposed by the natural environment will finally enter the human body through the food chain. This is the biggest hazard of plastic particles and the most important difference from recycling.

Leave a Reply

Your email address will not be published. Required fields are marked *